In this project, you are tasked with deployment and calibration of a traffic simulation model

in AIMSUN. The area to be modeled is a real roundabout in Melbourne, VIC. Empirical data

with regard to traffic volumes and origin-destination demand are provided. You need to

build the model in AIMSUN, calibrate the model, conduct an analysis on the impact of

signalisation and submit a short report describing the model and summarizing your analysis.

7 pages of a research on Hybrid Vehicle engine (automotive)

content of the research: 

1- Introduction of Hybrid engine (history, types, etc) note: (vehicle is both electrical motor and internal combustion engine)

2- pros and cons in terms of ( engineering perspective )

3- HOW is the internal combustion works with the electrical motor ( very important section)

4- conclusion

a link that could help to explain the mechanical properties of the engine:

https://www.intechopen.com/chapters/71269https://www.intechopen.com/chapters/71269

Read the following report on engineered lumber in Fire Conditions. Engineered Lumber in Fire Conditions.

Review the following websites’ content as well.Wood Aware
Preventing Injuries and Deaths of Fire Fighters Due to Truss System Failures

• Review all materials in the Wood Construction Section of the Additional Resources Tab.

Draft a 4-5 page paper about the report and sites.  Summarize the findings of your research.  

Attached the problem needs to be done, has a video similar showing how to get it done, please attach the original file with wordhttps://uttyler.instructuremedia.com/embed/c77380bd-ca28-4309-85c7-757b2ae5b1e6

https://uttyler.instructuremedia.com/embed/5a426e88-3bb4-4fa4-97df-ce60c844de86

Problem statement:

The frame shown in the figure is used to support a load of 1000 lb. Using Optimization tool in ANSYS, size the cross section of each member if standard size of steel I-beam are used.

I’m working on a electrical engineering discussion question and need a reference to help me learn.

Watch the video below.  After you have done so, submit an idea for an application that would be uniquely suited for the type of magnet technology covered in this video.  Explain the idea to me in 200-500 words.